Fitted to the outer edge of the wheel, RimskinsTM provide a barrier between the wheel rim and the kerb. RimskinsTM are intended to be a sacrificial product that will go on protecting the rims after many scrapes.

1. Ensure the ends of the RimskinsTM have been cut off squarely.

2. Peel 10cm of orange backing strip from adhesive strip.

3. Apply RimskinsTM from the top of the wheel rim and proceed in a clockwise direction, removing the backing strip as you go. Avoid direct contact with tape surface.

4. When application is complete, use scissors or a sharp blade to trim RimskinsTM to the correct length.

5. Firmly press RimskinsTM onto the rim.

6. To clean, wipe over with wax and grease remover and cloth.

Note: The adhesive used on RimskinsTM requires 24 hours to fully cure but is suitable for immediate use. Suitable for up to 20″ rims

Product Features

  • Fits up to 20″ Inch rims
  • Fitted to the outer edge of the wheel, RimskinsTM provide a barrier between the wheel rim and the kerb. RimskinsTM are intended to be a sacrificial product that will go on protecting the rims after many scrapes.
  • RimskinsTM will cover most gutter rash; however, if your rims are chipped or cracked, they may be dangerous and you should seek the advice of a wheel specialist before fitting RimskinsTM. For rims with existing damage, make sure any rough edges are smoothed or sanded first. The better you prepare your rims, the better RimskinsTM will work.
  • Read instructions contained before use. Apply RimskinsTM from the top of the wheel rim and proceed in a clockwise direction, removing the backing strip as you go. Avoid direct contact with tape surface.
  • WARNING: RimskinsTM are only designed to protect wheel rims against kerb damage incurred at low speed while parking. RimskinsTM are not designed to protect wheel rims against kerb damage incurred at normal driving speeds.

Click Here For More Information