The GPP 3.5″ Intake Manifold for your 07.5-16 Dodge 6.7L Cummins is built around a 3.5″ inlet that smoothly transitions to two 3″ mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower egt’s, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a gasket and hardware to make installing this intake extremely easy. Features: Unobstructed 3.5″ inlet to two 3″ mandrel bent tubes. 2 NPT ports Fully TIG welded with precise settings to produce optimal penetration without impacting airflow. 50-200 degrees F drop in EGT’s .5-1 MPG increase Deletes constrictive emissions equipment Significant gain in throttle response Faster turbo spool Note: You will need to delete all of your factory emissions equipment as this manifold does not have provisions to use any of it. This manifold is for off road use only. This product will work with dual CP3’s. CA Residents: Not legal for sale or use in California on pollution controlled motor vehicles.

Product Features

  • **PLEASE NOTE THIS PRODUCT IS NOT DENTED, IT IS CLEARANCE FOR THE FUEL LINE**
  • 3.5″ inlet to two 3″ mandrel bent tubes / 50-200 degrees F drop in EGT’s
  • Deletes restrictive emissions equipment
  • Significant gain in throttle response & Faster turbo spool
  • .5-1 MPG increase / 2 NPT ports

Click Here For More Information